User's Manual

Beacon Hardware Specifications and Installation 2 - 9
2.4 USB Beacon Part Number: MPACT-MB3000-01-WAR
A USB powered interface is required to power the USB Beacon. No additional hardware is required.
2.4.1 Installing the USB Style Beacon
Figure 2-9 shows a USB style beacon.
To activate a beacon part number - MPACT-MB3000-01-WR:
1. Insert the beacon into any standard USB power source.
Figure 2-9 USB Style Beacon - MPACT-MB3000-01-WR
When installing numerous beacons, group beacons by category configurations and activate the beacons prior to scanning
the barcodes and associating them with positions in the Toolbox.
2. After inserting the beacon(s) into any standard USB power source, associate the beacon in either offline or online mode in
the Toolbox application.
3. From the MPact Toolbox, select a site floor plan and an unassigned position for the beacon. Refer to the MPact Location &
Analytics Deployment Guide for information on how to install and deploy the beacon from the Toolbox.
NOTE: The USB beacon barcode is not on the beacon itself but on the on its plastic
packaging.