User's Manual

2 - 8 MPact Location & Analytics Hardware Installation Guide
3. Hand tighten the screws to firmly secure the beacon.
Figure 2-7 Outdoor Style Beacon (backside).
Figure 2-7 Back of Outdoor Style Beacon Outdoor Beacon
Figure 2-8 Outdoor Style Beacon (Top).
Figure 2-8 Top of Outdoor Style Beacon - MPACT-MB4000-01-WR
To activate a beacon part numbers - MPACT-MB4000-01-WR:
4. Press the capacitive switch on the top of the beacon housing. Refer to Figure 2-8.
The barcode label should face up toward the ceiling and the smooth front of the beacon should face out to where the mobile
client is expected to engage.
Refer to the following table about operating modes:
NOTE: Ensure the beacon is positioned correctly, Once the beacon is mounted it will be
difficult to remove.
NOTE: When installing numerous beacons, group beacons by category configurations
and activate the beacons prior to scanning the barcodes and associating them with
positions in the Toolbox.
Mode Sleep Configuration Broadcast LED Behavior
0-2 seconds No action No action No action
2+ -7 Broadcast Broadcast Broadcast Solid light
7+ - 12 Move to
configuration
Remain in
configuration
Move to
configuration
Slow flash when
button flashes 300
ms on / 300ms off.
+ 12 Sleep Sleep Sleep Fast flash – 100ms
/on & off