User's Manual
Table Of Contents
- About this Guide
- MPact Bluetooth® Smart beacon Overview
- Beacon Hardware Specifications and Installation
- 2.1 RB Beacon Part Number: MPACT-T1B20-000-WR
- 2.2 RB Beacon Part Number: MPACT-T1B10-000-WR
- 2.3 2AA Beacon Part Number: MPACT-MB2000-01-WR
- 2.4 USB Beacon Part Number: MPACT-MB3000-01-WAR
- 2.5 Beacon Part Numbers: MPACT-MB4000-01-WR and MPACT-MB4001-01-WR
- 2.6 MPACT-MB4000-01-WR and MPACT-MB4001-01-WR Antenae Positions
- 2.7 Beacon Battery Replacement
- Customer Support
2 - 6 MPact Location & Analytics Hardware Installation Guide
2. Activate one or more beacons by pulling the mylar strip out from inside the beacon housing.
Figure 2-6 shows the back of a Indoor style beacon.
Figure 2-6 Indoor Style Beacon - MPACT-MB3000-01-WR
2.3.2 Beacon Operating Modes Definded
Refer to the following table for beacon operating modes definitions.
Refer to the following table for information about
Indoor Style Beacon operating modes:
CAUTION: After pulling off the last mylar strip, you have 20 seconds to associate the
beacon in either offline or online mode using the Toolbox application.
Mode Definition
Sleep The beacon is not transmitting nor will it accept connections from clients.
Configuration The beacon is in a state where it accepts connections from clients. Clients can configure the device
when connected.
Broadcast The beacon is transmitting packets that conform to one of the supported beacon formats (iBeacon,
MPact, Battery Save, and SecureCast).
Mode Sleep Configuration Broadcast LED Behavior
0-2 seconds No action No action No action
2+ -5 Broadcast Broadcast Broadcast Slow flash when
button flashes 300
ms on / 300ms off.
5+ - 10 Move to
configuration
Remain in
configuration
Move to
configuration
Fast flash – 100ms
/on & off
+ 10 Sleep Sleep Sleep Solid light