User's Manual

CHAPTER 2 BEACON HARDWARE
SPECIFICATIONS AND INSTALLATION
The following setup processes must be complete as a prerequisite to installing beacon hardware:
• MPact Server Installation and Setup - see the MPact Location & Analytics Deployment Guide
• MPact Toolbox and Beacon Installation - see the MPact Location & Analytics Deployment Guide
Lozier® Shelves
Beacon brackets for the MPACT-T1B20-000-WR and MPACT-T1B10-000-WR can be used with the following Lozier products:
• TL Shelf
•DL Shelf
•HL Shelf
• Standard Base Deck
2.1 RB Beacon Part Number: MPACT-T1B20-000-WR
As a prerequisite, the following hardware items are required to mount the tie-wrap style beacon housing to a pole or similar
structure:
• Beacon (tie-wrap style housing), part number - MPACT-T1B20-000-WR. (When ordering, use the following part number:
MPAC-T1B20-250-WR (Box of 25)
• Plastic tie wraps for attaching each beacon housing to the shelf
2.1.1 Installing the Tie-Wrap Style Beacon
Tie-wrap beacon housings are designed to attach to vertical or horizontal poles or similar mounting surfaces. In Figure 2-1, there
are openings located on the back of the beacon housing allowing a tie wrap to be inserted through the openings and wrapped
around a pole or similar structure.
Notice the up arrow located on the middle of the beacon housing. This arrow indicates the optimal orientation for the beacon
to function properly. Additionally, the smooth front of the beacon should face outward toward the aisle where client devices
are expected to engage (dwell).
Figure 2-1 shows a beacon with the mylar strip attached to the left-hand side of the housing.