User's Manual
Table Of Contents
- Product Introduction
- Infrastructure Device Installation
- Device Configuration
- License Information
- Customer Service
- Certification and Safety Information
- FCC Regulatory Information
- Safety Information for the MOTOMESH Products
- Safety Certification
- Regulatory Requirements and Legal Notices
- Regulatory Requirements for CEPT Member States (www.cept.org
- European Union Notification
- Equipment Disposal
- UK Notification
- Belgium Notification
- Luxembourg Notification
- Czech Republic Notification
- Norway Notification
- Greece Notification
- DECLARATION OF CONFORMITY
- EU Declaration of Conformity for RoHS Compliance
- CMM Labeling and Disclosure Table
- Software License Terms and Conditions
Chapter 6: Certification and Safety Information
November 2007
6-4
2011. This 2.4 GHz equipment is “CE” marked to show compliance with the
European Radio & Telecommunications Terminal Equipment (R&TTE) directive 1999/5/EC and that
National restrictions apply.
Where necessary, the end user is responsible for obtaining any National licenses required to operate
this product and these must be obtained before using the product in any particular country. However,
for CEPT member states, 2.4 GHz Wideband Data Transmission equipment has been designated
exempt from individual licensing under decision ERC/DEC(01)07. For EU member states, RLAN
equipment in both the 2.4 & 5.4GHz bands is exempt from individual licensing under Commission
Recommendation 2003/203/EC. Contact the appropriate national administrations for details on the
conditions of use for the bands in question and any exceptions that might apply. Also see
http://www.ero.dk
for further information.
Motorola MOTOMESH dual radio Radio equipment operating in the 5470 to 5725 MHz band also
operates in the 2400 to 2483.5MHz band and is categorized as “Class 2” devices within the EU
because of the additional 2.4GHz radio. These devices will become “Class 1” devices after 2011 when
the restrictions on the 2.4GHz band are removed but are currently “CE” marked
to show compliance with the European Radio & Telecommunications Terminal Equipment (R&TTE)
directive 1999/5/EC and that National restrictions apply.
Relevant Declarations of Conformity can be found at
http://motorola.canopywireless.com/support/software/index.php?catid=10
European Union Notification
The CE mark is the official marking required by the European Community for all Electric and
Electronic equipment that will be sold, or put into service for the first time, anywhere in the European
community. It proves to the buyer or user that this product fulfills all essential safety and
environmental requirements as they are defined in the European Directives.
Motorola Products are covered under the following product certification Europe:
ETSI EN 300 328 V 141 (2003-04)
ETSI EN 301 489-1 (2002-08) and EN 301 489-17
EN 55022:1998 and EN 55024:1998
CENELEC EN 50360 and EN50371 – Specific Absorption Test – SAR
European Union Notification 5.7GHz Product
The 5.7 GHz MOTOMESH is a Class 2 device and uses operating frequencies that are not harmonized
throughout the EU member states. The operator is responsible for obtaining any national licenses
required to operate this product and these must be obtained before using the product in any particular
country. The 5.7GHz MOTOMESH dual radio products also operate in the 2.4GHz band – see other
sections of this document for restrictions on operating in the 2.4GHz band.