User's Manual
Table Of Contents
- Product Introduction
- Infrastructure Device Installation
- Device Configuration
- License Information
- Customer Service
- Certification and Safety Information
- FCC Regulatory Information
- Safety Information for the MOTOMESH Products
- Safety Certification
- Regulatory Requirements and Legal Notices
- Regulatory Requirements for CEPT Member States (www.cept.org
- European Union Notification
- Equipment Disposal
- UK Notification
- Belgium Notification
- Luxembourg Notification
- Czech Republic Notification
- Norway Notification
- Greece Notification
- DECLARATION OF CONFORMITY
- EU Declaration of Conformity for RoHS Compliance
- CMM Labeling and Disclosure Table
- Software License Terms and Conditions
Chapter 3: Device Configuration
November 2007
3-16
4
To Promote the device back to an IAP, right-click on the device in the Device Tree and choose Promote to
an IAP from the pop-up menu.
5
From the newly opened Promote/Demote dialog box, select Yes to continue promoting the device, or
select No.
6
The device icon will be moved from the MWR group to the IAP group in the Device Tree.
Second IP Stack Aids in Troubleshooting
.............................................
.
.
The second IP Stack feature is available in MOTOMESH Duo 4300 devices and allows for a pre-
configured SSID and connectivity to a fixed IP. This feature can assist you with correcting and
diagnosing some cases of stranded units rather than having to roll a bucket truck. Operators will find
this feature helpful when configuring nodes for expansion or replacement.
Second IP Stack Settings
A MOTOMESH Duo device can be accessed via an 802.11b/g client access card (a PCMCIA Wireless
Client Card) that is attached to a laptop computer. The client access card must be set to the settings
specified in the MeshManager Users Guide Device Recovery Configuration Tab section to enable a
successful connection.
VAP 15 information is to be used only for Second IP Stack data.
Accessing the MOTOMESH Duo Device Recovery Settings in
MeshManager
Procedure 3-3 Accessing the MOTOMESH Duo Device Recovery Settings
1
Select a specific device from the Device Tree in MeshManager.
2
From the right side of the screen, select Global Configuration from the Action drop-down list.
3
Select the Device Recovery tab.
4
View the Default VAP 15 Settings setup for the purpose of device recovery.
5
You can choose to keep the default settings or change them after your wireless network is setup,
configured, and working properly.