User's Manual
Table Of Contents
- Product Introduction
- Infrastructure Device Installation
- Device Configuration
- License Information
- Customer Service
- Certification and Safety Information
- FCC Regulatory Information
- Safety Information for the MOTOMESH Products
- Safety Certification
- Regulatory Requirements and Legal Notices
- Regulatory Requirements for CEPT Member States (www.cept.org
- European Union Notification
- Equipment Disposal
- UK Notification
- Belgium Notification
- Luxembourg Notification
- Czech Republic Notification
- Norway Notification
- Greece Notification
- DECLARATION OF CONFORMITY
- EU Declaration of Conformity for RoHS Compliance
- CMM Labeling and Disclosure Table
- Software License Terms and Conditions
Chapter 3: Device Configuration
November 2007
3-12
23
A successfully configured device will display the same information in the entry fields and check boxes that
were intended when configuring the device. Incorrectly displayed entry fields or check boxes will be a sign
of a failed device configuration.
You can also check the progress log for the following characteristics:
- 802.11a radio status enabled
- 802.11a mesh status enabled
- Probe found DHCP IP addressing
- Successfully wrote 802.11a ….
- Successfully wrote License Key xxxxxxxxxx (newly added license key #)
When adding a Dual Radio device that has been preconfigured from the
factory, a license key IS NOT required. A Failed to write License Key
message will appear in the Progress Log. This is expected behavior and
you can disregard the message.
- Successfully wrote VLAN Membership xxxxxxxxx (newly added license key #)
- Completed writing device name to subcomponents.
Figure 3-17 After Successfully Adding a Device to the Mesh
24
If any errors are detected, you should delete the device from the Device Tree and start over with the
specific device.
To delete a device, right-click on the in the Device Tree, and then select Delete Device from the pop-up
menu.