User's Manual
Table Of Contents
- Product Introduction
- Infrastructure Device Installation
- Device Configuration
- License Information
- Customer Service
- Certification and Safety Information
- FCC Regulatory Information
- Safety Information for the MOTOMESH Products
- Safety Certification
- Regulatory Requirements and Legal Notices
- Regulatory Requirements for CEPT Member States (www.cept.org
- European Union Notification
- Equipment Disposal
- UK Notification
- Belgium Notification
- Luxembourg Notification
- Czech Republic Notification
- Norway Notification
- Greece Notification
- DECLARATION OF CONFORMITY
- EU Declaration of Conformity for RoHS Compliance
- CMM Labeling and Disclosure Table
- Software License Terms and Conditions
MOTOMESH DUO 2.0 4300 Users Guide
November 2007
3-11
21
Observe the Progress Log for any errors.
Notice that the new device is now displayed in the IAP group in the Device Tree in MeshManager.
Figure 3-16 After Adding a Device to the Mesh
When adding a Dual Radio device that has been preconfigured from the
factory, a license key IS NOT required. A Failed to write License Key
message will appear in the Progress Log. This is expected behavior and
you can disregard the message.
22
To verify the new device configuration, select the Probe button again to re-probe the device.
If there are any errors at the time that a device is added, performing a re-
probe will confirm a successful configuration.