User's Manual
Table Of Contents
- Product Introduction
- Infrastructure Device Installation
- Device Configuration
- License Information
- Customer Service
- Certification and Safety Information
- FCC Regulatory Information
- Safety Information for the MOTOMESH Products
- Safety Certification
- Regulatory Requirements and Legal Notices
- Regulatory Requirements for CEPT Member States (www.cept.org
- European Union Notification
- Equipment Disposal
- UK Notification
- Belgium Notification
- Luxembourg Notification
- Czech Republic Notification
- Norway Notification
- Greece Notification
- DECLARATION OF CONFORMITY
- EU Declaration of Conformity for RoHS Compliance
- CMM Labeling and Disclosure Table
- Software License Terms and Conditions
MOTOMESH DUO 2.0 4300 Users Guide
November 2007
3-9
17
Decide if you want the device to be an IAP or an MWR on your network.
The Device is an IAP checkmark is ENABLED by default. If you wish to add a device to the Network as
a MWR, simply uncheck the check box associated with this selection.
All MOTOMESH Duo 4300 devices are initially preconfigured as IAPs. If
you wish to demote an IAP to a WR after it has been added to the
Network, you can do so at a later time.
Figure 3-12 Configuring a Device to be an IAP or WR
18
Enter a device name into the Device Name entry field. Follow the device network naming conventions
established for your network.
No spaces are allowed when entering a Device Name. Your entry must be
a fully qualified Domain Name.
If a device name is not entered, MeshManager will randomly generate a
unique name.
Figure 3-13 Entering a Device Name