User's Manual
Table Of Contents
- Product Introduction
- Infrastructure Device Installation
- Device Configuration
- License Information
- Customer Service
- Certification and Safety Information
- FCC Regulatory Information
- Safety Information for the MOTOMESH Products
- Safety Certification
- Regulatory Requirements and Legal Notices
- Regulatory Requirements for CEPT Member States (www.cept.org
- European Union Notification
- Equipment Disposal
- UK Notification
- Belgium Notification
- Luxembourg Notification
- Czech Republic Notification
- Norway Notification
- Greece Notification
- DECLARATION OF CONFORMITY
- EU Declaration of Conformity for RoHS Compliance
- CMM Labeling and Disclosure Table
- Software License Terms and Conditions
MOTOMESH DUO 2.0 4300 Users Guide
November 2007
3-5
8
When ordering a Single Radio device from the factory, note that after initial Probing during the Add New
Device procedure, the 802.11b/g Radio and Mesh are both
ENABLED by default and the 802.11a Radio
and Mesh are both DISABLED by default.
Figure 3-5 Examining Initial Device Defaults in MeshManager
DO NOT enter any License Key or Membership VLAN information.
To complete this procedure, go to Step 18 below.
9
When enabling the 802.11a Radio and Mesh on a 4300-49 device, select the 802.11a Radio Active check
box AND the Mesh Enabled check box.
Figure 3-6 Enabling the 802.11a Radio on a 4300-49 Device
Both Meshes will be enabled.
To complete this procedure, go to Step 18 below.