User's Manual
Table Of Contents
- Product Introduction
- Infrastructure Device Installation
- Device Configuration
- License Information
- Customer Service
- Certification and Safety Information
- FCC Regulatory Information
- Safety Information for the MOTOMESH Products
- Safety Certification
- Regulatory Requirements and Legal Notices
- Regulatory Requirements for CEPT Member States (www.cept.org
- European Union Notification
- Equipment Disposal
- UK Notification
- Belgium Notification
- Luxembourg Notification
- Czech Republic Notification
- Norway Notification
- Greece Notification
- DECLARATION OF CONFORMITY
- EU Declaration of Conformity for RoHS Compliance
- CMM Labeling and Disclosure Table
- Software License Terms and Conditions
Chapter 3: Device Configuration
November 2007
3-4
6
After entering the Ethernet MAC address for the device, click Probe.
The probing operation will ensure that the device is communicating with the MiSC in addition to capturing
the other MAC Addresses.
Figure 3-3 Selecting the Probe Button in MeshManager
7
When ordering a Dual Radio device with an active 5.8GHz or 5.4GHz 802.11a radio, the device is
preconfigured from the factory with both the 802.11b/g and 802.11a radios active.
When the Add New MOTOMESH Duo Device panel is displayed as you add the device to the network,
note that the 802.11b/g Radio is ENABLED by default and the 802.11a Radio and Mesh are both
enabled
by default.
The 802.11a License Key string and 802.11a Membership VLAN default setting (0-4095) will be
displayed. Since the settings for a Dual Radio have been preconfigured with the factory defaults for the
device, the license key is not required.
You do not need to make any changes to these parameters.
Figure 3-4 Dual Radio 4300 Device Preconfigured with 5.8/5.4 802.11a Radio Active
To complete this procedure, go to Step 18 below.