User's Manual
Table Of Contents
- Product Introduction
- Infrastructure Device Installation
- Device Configuration
- License Information
- Customer Service
- Certification and Safety Information
- FCC Regulatory Information
- Safety Information for the MOTOMESH Products
- Safety Certification
- Regulatory Requirements and Legal Notices
- Regulatory Requirements for CEPT Member States (www.cept.org
- European Union Notification
- Equipment Disposal
- UK Notification
- Belgium Notification
- Luxembourg Notification
- Czech Republic Notification
- Norway Notification
- Greece Notification
- DECLARATION OF CONFORMITY
- EU Declaration of Conformity for RoHS Compliance
- CMM Labeling and Disclosure Table
- Software License Terms and Conditions
Chapter 2: Infrastructure Device Installation
November 2007
2-8
Figure 2-7 Side View (B) of the 4300 External Connection Points
Figure 2-8 Side View (A) of the 4300 External Connection Points
Personality Plug Usage Information
Procedure 2-1 Personality Plug Usage Information
Reset Plug Usage Information
An optional Red Hardware Reset Plug (looks like a red personality plug, not shown above) is used to
reset a 4300 device back to its factory default configuration.
1
Connect an external PoE device to the POE OPT port on the 4300 unit with the Ethernet cable provided.
2
Connect the Canopy Connect or Standards based 802.3 af PoE Personality Plug to the Personality Port
(shown above) AFTER the Ethernet cable has been connected to the desired external device.
Personality
Plug Port
showing the
Canopy
Connect
Plug.(Black).
Personality
Plug Port
showing port
cover when
no plug is
attached.