User Manual

43
QL Series User Guide
QL 420 WLAN Module Using PCMCIA Radio
The following section only applies when the PCMCIA WLAN module (FCC ID: I28-QL420352) is installed in
the QL 420 printer. (Note that only one of the radio options can be installed in the printer at one time). The
antenna used for this transmitter must not be co-located or must not operate in conjunction with any other
antenna.
The FCC ID number label is on the label on the front of the QL 420. On all models the text can be read with
the radio module installed.
Caution • Use of the QL 420 with the radio module marked with
“FCC ID: I28-QL420352” meets the FCC requirements for radio
frequency (RF) radiation exposure in the standard body worn
configuration with no minimum separation. In this configuration,
which applies whether the belt clip or shoulder strap is used, the face
of the printer from which paper is transported is facing away from the
user’s body. The standard configuration must always be used when
the printer is body worn. This configuration maintains the required 1
cm separation distance.
The printer with this radio option has been SAR tested. The
maximum SAR value measured was 1.04. W/kg averaged over
1 gram.
European Regulatory Information for this Radio
AT BE CY CZ DK
EE FI FR DE GR
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE GB
Note: -Member states in the EU with restrictive use for this device are
crossed out!
This device is also authorized for use in all EFTA member states (CH, ICE, LI,
NOR)
0336
Important Notice:
This device is a portable RF printer intended for
commercial and industrial use in all EU and EFTA
member states except in France where restrictive
use applies.
continued