User Manual

QL Series User Guide

0168

Important Notice:

This device is a portable RF printer intended

for commercial and industrial use in all EU and

EFTA member states except in France where

restrictive use applies.

continued

WLAN Module Using 802.11b CF Radio

(Asia & EU Countries)

The following section only applies when the CF (Compact Flash) WLAN module (With FCC ID: H9PLA4137)

is installed in a QL series printer. Other than conditions speciﬁed elsewhere in this manual, only one of the

radio options can be installed in the printer at one time and the antenna used for these transmitters must not

be co-located or must not operate in conjunction with any other antenna.

QL model printers have the FCC ID number label on the front of the module, and QL Plus models have the

FCC ID number on a label on the back of the unit.

Caution • Use of a QL series printer with the radio module marked

with FCC ID:H9PLA4137 meets the FCC requirements for radio

frequency (RF) radiation exposure in the standard body worn

conﬁguration with no minimum separation. In this conﬁguration,

which applies whether the belt clip or shoulder strap is used, the face

of the printer from which paper is transported is facing away from the

user’s body. The standard conﬁguration must always be used when

the printer is body worn.

European Regulatory Information for this Radio

AT BE CY CZ DK

EE FI FR DE GR

HU IE IT LV LT

LU MT NL PL PT

SK SI ES SE GB

Note: -Member states in the EU with restrictive use for this device are crossed

out!

This device is also authorized for use in all EFTA member states (CH, IS, LI, NO)