User's Manual
54
QLn Series User Guide
Label Specications
Parameter
QLn320
Media Width
1.0 in. to 3.125 in. (38,1 to 78,4 mm)
Max/Min Label Length
0.5 in. minimum to 32 in. maximum
Inter-label Gap.
0.08 in. to 0.16 in. (.12 in. preferred)
(2 mm to 4 mm, 3 mm preferred)
Label Thickness 0.0023 in to 0.0065 in (0.058 mm to 0.165 mm)
Tag Thickness 0.0060 in. (0.152 mm) maximum
Max. Label Roll dia.
2.63 in. (66,8 mm) O.D.
Label Inner Core**
0.75 in. (19 mm) or 1.38 in (35,05 mm) minimum dia. for linered
1.38 in. (35,05 mm) minimum dia. for linerless media
Black Mark Dimensions
The reflective media black marks should be centered
on the media roll.
Media Requirements
Minimum mark width: 0.5 in. (12,7 mm) perpendicular
to inside edge of media, centered within the width of
the roll.
Mark length: 0.12 in. to 0.43 in. (3-11 mm) parallel to
inside edge of media
Use Zebra brand direct thermal media that is outside wound. Media
may be reective (black mark) sensing, or transmissive (gap) sensing,
die-cut, continuous, or linerless.
For die-cut labels, use only full auto dies.
** QLn320 supports coreless media which is 0.75 in. (19 mm) in diameter.