User Manual

ManualsBrandsZebra Technologies ManualsElectronicsZebra BT radio

1. InstalltheMLBinprinterhousing.Tightenthescrewhighlightedinred(seefigure1).



Figure1

2. Ontheprinthead/radiomodulechassis,installcoaxialcableasshowninfigure2andmoveitawayfromthe

motorasshowninfigure3.

  

Figure2Figure3

3. Pullthecoaxialcablefromthebottomofchassissothattheopenendofthecablecomesoutfrombottomside

ofradiomodule.Seefigures4and5fordetails.

  

Figure4Figure5

Summary of content (5 pages)

PAGE 1
. Install the MLB in printer housing. Tighten the screw highlighted in red (see figure 1). Figure 1 2. On the print head/radio module chassis, install coaxial cable as shown in figure 2 and move it away from the motor as shown in figure 3. Figure 2 Figure 3 3. Pull the coaxial cable from the bottom of chassis so that the open end of the cable comes out from bottom side of radio module. See figures 4 and 5 for details.
PAGE 2
4. Install the print head flex cable into the connector as shown in figure 6. Note that the flex cable has to be pushed into the chassis. Figure 6 5. Install the motor cable and sensor cable as shown in figures 7 and 8 respectively. Figure 7 Figure 8 6. Install the antenna PCBA on the top cover through plastic guides highlighted in figure 9.
PAGE 3
Figure 9 Figure 10 7. Connect the open end of coaxial cable to the antenna PCBA as shown in figure 11. Figure 11 8. Apply Kapton tape on coaxial cable to ensure that the cable is oriented perpendicular w.r.t. antenna PCBA. Figure 12 9. Install the button and close the top cover as shown in figure 13.
PAGE 4
Figure 13 10. Install screws at locations highlighted in figures 14, 15 and 16. Install battery and tighten the lock.
PAGE 5
Figure 16