User's Manual

25
MZ Series User Guide
WLAN Module Using 802.11b/g Radio
The following section only applies when the 802.11b/g
WLAN module (With FCC ID: I28MD-ZLAN11G) is installed
in a MZ series printer. Only one of the radio options can be
installed in the printer at one time and the antenna used for
these transmitters must not be co-located or must not operate
in conjunction with any other antenna.
MZ series printers have the FCC ID number on a label on the
back of the unit.
Caution • Use of a MZ series printer with the radio module marked
with FCC ID: I28MD-ZLAN11G meets the FCC requirements for
radio frequency (RF) radiation exposure in the standard body worn
configuration with no minimum separation. In this configuration,
which applies whether the belt clip or shoulder strap is used, the face
of the printer from which paper is transported is facing away from the
user’s body. The standard configuration must always be used when
the printer is body worn.
The MZ 220 and MZ 320 printers with this radio option have
been SAR tested. The maximum SAR value measured for
each model is listed below:
Model
SAR value W/Kg 1g average))
MZ220 .049
MZ 320 .038
European Regulatory Information for this Radio
AT BE CY CZ DK
EE FI FR DE GR
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE GB
Note: -Member states in the EU with restrictive use for this device are
crossed out!
This device is also authorized for use in all EFTA member states (CH, IS, LI, NO)
Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU and
EFTA member states except in France where
restrictive use applies.
continued