User's Manual
Table Of Contents
- Proprietary Statements
- Document Conventions
- Introduction to the MZ Series
- Unpacking and Inspection
- Reporting Damage
- MZ Series Introduction
- Getting Ready to Print
- Battery
- Installing the Battery
- MZ Series Quad Docking Station
- Battery Safety
- Charger Safety
- Charging the Battery
- Loading the Media (All models)
- Operator Controls
- Verify the Printer Is Working
- Printing a Configuration Label
- Connecting the Printer
- Cable Communication
- IR Communications
- Wireless Communications with Bluetooth™
- Bluetooth Networking Overview
- WLAN Overview
- Setting Up the Software
- Radio Regulatory Information
- Zebra Bluetooth Radios ZBR3
- WLAN Module Using 802.11g Radio
- Wearing the Printer
- Belt Clip
- Adjustable Shoulder Strap
- Preventive Maintenance
- Extending Battery Life
- General Cleaning Instructions
- Troubleshooting
- Interpreting Indicators
- Troubleshooting Topics
- Resetting an MZ Series Printer
- Troubleshooting Tests
- Printing a Configuration Label
- Communications Diagnostics
- Calling Technical Support
- Specifications
- Printing Specifications
- Memory and Communications Specifications, MZ series
- Media Specifications
- Font and Bar Code Specifications for MZ Series
- USB Communications Port
- Physical, Environmental and Electrical Specifications
- MZ Series Accessories
- Appendix A
- Interface Cables
- USB Cable
- More Interface Cables
- Appendix B
- Appendix C
- Appendix D
- Battery Disposal
- Product Disposal
- Appendix E
- Product Support
- Product Support Contacts
- Appendix E
- Index
- Patent Numbers
24
MZ Series User Guide
Important Notice:
This device is a portable RF printer intended for commercial and
industrial use in all EU and EFTA member states.
Radio Regulatory Information
Zebra Bluetooth Radios MZ-ZBR3
Caution • Exposure to Radio Frequency Radiation. The radiated output
power of this internal Bluetooth radio is far below the FCC radio
frequency exposure limits. The internal Bluetooth radio operates
within guidelines found in radio frequency safety standards and
recommendations. Do not use the printer in an unauthorized manner.
Note • The following section only applies when the MZ-ZBR3
(FCC ID: I28MD-BTC2TY6) Bluetooth Radio is installed in a MZ series
printer. The antenna used for this transmitter must not be co-located
or must not operate in conjunction with any other antenna.
European Regulatory Information for this Radio
This device is intended for use in all EU and EFTA member states.
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive
1999/5/EC. The following test methods have been applied in order to prove
presumption of compliance with the R&TTE Directive 1999/5/EC:
• EN55022:1998
European Immunity Standard
• EN 60950: 2000
Safety of Information Technology Equipment
• EN 300 328-2 V1.4.1 (2003-04)
Technical requirements for spread-spectrum radio equipment
• EN 301 489-1/-17 V1.5.1/1.2.1 (2003-12) -17 v1.2.1 (2002-08)
EMC requirements for spread-spectrum radio equipment.
This device is a 2.4 GHz wireless LAN transceiver, intended for indoor home and
office use in all EU and EFTA member states.