User's Manual
Table Of Contents
- Proprietary Statements
- Document Conventions
- Introduction to the MZ Series
- Unpacking and Inspection
- Reporting Damage
- MZ Series Introduction
- Getting Ready to Print
- Battery
- Installing the Battery
- MZ Series Quad Docking Station
- Battery Safety
- Charger Safety
- Charging the Battery
- Loading the Media (All models)
- Operator Controls
- Verify the Printer Is Working
- Printing a Configuration Label
- Connecting the Printer
- Cable Communication
- IR Communications
- Wireless Communications with Bluetooth™
- Bluetooth Networking Overview
- WLAN Overview
- Setting Up the Software
- Radio Regulatory Information
- Zebra Bluetooth Radios ZBR3
- WLAN Module Using 802.11g Radio
- Wearing the Printer
- Belt Clip
- Adjustable Shoulder Strap
- Preventive Maintenance
- Extending Battery Life
- General Cleaning Instructions
- Troubleshooting
- Interpreting Indicators
- Troubleshooting Topics
- Resetting an MZ Series Printer
- Troubleshooting Tests
- Printing a Configuration Label
- Communications Diagnostics
- Calling Technical Support
- Specifications
- Printing Specifications
- Memory and Communications Specifications, MZ series
- Media Specifications
- Font and Bar Code Specifications for MZ Series
- USB Communications Port
- Physical, Environmental and Electrical Specifications
- MZ Series Accessories
- Appendix A
- Interface Cables
- USB Cable
- More Interface Cables
- Appendix B
- Appendix C
- Appendix D
- Battery Disposal
- Product Disposal
- Appendix E
- Product Support
- Product Support Contacts
- Appendix E
- Index
- Patent Numbers
15
MZ Series User Guide
Loading the Media (All models)
1. Open the printer: Refer to Figure 6.
• Press the latch release button on the top of the printer as
shown at “1” below. The media cover will flip open auto-
matically revealing the media compartment.
2. Load the media: Refer to Figure 7
• Insert the roll of media into the media compartment.
Ensure that the media pulls off the core in the direction
shown in Figure 6.
3. Close the Media Cover: Refer to Figure 8.
• Pull a short length of media out of the printer
• Close the Media Cover firmly and ensure it is securely
latched on both sides..
• Turn on the printer and press the Feed button.
The printer will advance media until the Feed button is re-
leased. Verify the media is feeding properly and without
binding or skewing sideways
Figure 6: Opening the MZ Printer (MZ 220 shown)
continued
Media Compartment
Latch Release
Button