User's Manual

11
MZ Series User Guide
When the battery is first installed, the printer power and
charge indicators should indicate the battery is not fully
charged (see “Charging the Battery” below and “Operator
Controls”).
You must charge the battery fully before using the printer
for the first time. To ensure maximum battery capacity, new
batteries should go through two or three complete charge/dis-
charge cycles when first put into service.
Charging the Battery
Preparing the Charger Power Supply
Before charging the battery for the first time, you must pre-
pare the Charger power Supply. Refer to Figure 3
Figure 3: Preparing the Charger Power Supply
continued
1. Remove the power supply from its box.
Remove and discard the shipping ring from the
mains receptacle cavity.
Shipping Ring
Remove and discard
2. Verify that the mains adapter shipped with your
Printer is the correct one for your region.
3. Install the mains adapter into the Power Supply
by hooking the top edge into the mains receptacle
cavity, and rotating it until it snaps into place.
Mains Adapter