Data Sheet

916 Wireless Block Diagram
(Part Number CC13626)
Software When the Intelligent Wireless Controller (P/N CQ13967) is not used, Comtec can provide C
source code for a CS/CDMA collision avoidance communications protocol. This software
supports multiple radio pairs operating in proximity to each other, and implements error
detection, retries and radio address association. The radio address association algorithm is
based on radio or product serial number.
Regulatory Approvals: FCC Modular, ID Number: I28MD-TRCV-9CMHZ
Canada T.B.D.
Physical Connectors: Antenna - SSMT, M/A-COM part number 2367-5002-54
Data - (J1) 8 pin female, Samtec part number SLM-108-01-S-S
Ground (J2 & J3)- 2 pin female, Samtec part number SLM-102-01-S-S
TX SECTION
DATA
BUFFERS
DATA
BUFFERS
CONTROL
LOGIC
TXD
RXD
SLEEP/
AWAKE*
TX/RX*
RX SECTION
TRANSCIEVER
MODULE
0.000
0.000 0.000
0.396
0.196
0.275
0.500
0.804
0.725
1.000
0..090
0..224 2..223
2..189 1.160
2..357 2..447
0.000
0.210
0.250
0.062
0.080
J1
J2
J3
1
1
1
8
.125, 2 places
Antenna Connector
Connectors mate with Samtec MTMS family. Part number is dependent on desired board
spacing.
Dimensions:
©1996-2000 Comtec Information Systems, Inc. All rights reserved.
Specifications for information purposes and are subject to change.
All products and brand names are trademarks of their respective companies.
Comtec
TM
is a registered trademark of Comtec Information Systems, Inc.
4/00 Rev. 1.0.
1
Comtec antenna or equivalent is used.
2
All signals operate at CMOS levels.