User's Manual

RF FILTER
TX SAW
MODULE
DATA
BUFFERS
RX SAW
MODULE
DATA
BUFFERS
CONTROL
LOGIC
TXD
RXD
SLEEP/
AWAKE*
TX/RX*
TX
MIX
RX
MIX
LOCAL
OSCILLATOR
0.000
0.235
0.312
0.540
0.845
0.768
1.080
0.194
2.189 1.364
2.357 2.447
0.000
0.070
0.250
0.062
0.080
J1
J2
J3
1
8
.125, 2 places
Antenna Connector
2.253
1
1
0.000
0.120
0.090
2400 Wireless
Block Diagram
Software When the Intelligent Wireless Controller (P/N CQ13967-1) is not used, Zebra can provide
C source code for a CS/CDMA collision avoidance communications protocol. This soft-
ware supports multiple radio pairs operating in proximity to each other, and implements
error detection, retries and radio address association. The radio address association
algorithm is based on radio or product serial number.
Regulatory Approvals: FCC Modular, ID Number: I28MD-TRCV-24GHZ
Canada: Canada RSS210 Certification # 37981032228A
Product Labelling Any final product that contains this radio must have a
Requirements permanently affixed label visible from the outside of the
product that says the following: “Contains FCC ID:
I28MD-TRCV-24GHz.”
Physical Connectors: Antenna - SSMT, M/A-COM part number 2367-5002-54
Data (J1) - 8 pin female, Samtec part number SLM-108-01-S-S
Optional ground connectors (J2, J3)- 2 pin female, Samtec part
number SLM-102-01-S-S
Connectors mate with Samtec MTMS family. Part number is dependent on
desired board spacing.
Dimensions:
©2000 Zebra Technologies Corporation all rights reserved.
Specifications for information purposes and are subject to change.
WARNING: Changes or modifications to this radio not expressly approved by Zebra Technologies
Corporation may void the user’s authority to operate the equipment under the modular approval with
FCC ID# I28MD-TRCV-24GHZ.
Likewise, the antenna used with this radio must be approved by Zebra for the modular approval to be
valid.
All products and brand names are trademarks of their respective companies.
P/N AT 15380 10/2000 Rev. 1.2