User's Manual

QL 420 User’s Guide 35
Desk Stand
Refer to Figure 16. To use the
Desk Stand: Slide the QL 420 onto
the Desk stand as shown. The QL
420’s belt clip will hook onto the
Desk Stand as shown and retain it
in place. Ensure that the clip is se-
curely attached to the Stand and the
media compartment of the printer is
seated securely in the stand.
Holes are provided to permanent-
ly attach the Desk Stand to the work
surface. The charger and data I/O
cables may be plugged into the
printer in the usual manner.
Refer to the section on using the
chargers for more information.
Adjustable Shoulder
Strap
Refer to Figure 17. If
your printer is equipped
for the shoulder strap op-
tion: snap each end of
the shoulder strap into
the “D” rings in the top of
the printer. Slide the
buckle away from or to-
wards the printer until you
achieve the desired
length.
FIGURE 17: OPTIONAL SHOULDER STRAP
Hold Buckle
Pull Strap here
to lengthen
Pull Strap here
to shorten
Snap in to “D”
rings on printer
FIGURE 16: OPTIONAL DESK STAND
Desk Stand
Hook Belt
Clip over the
Stand