User Manual

O-10
Cameo 2/3 Series User Guide
Batteries and Charging
Conditioning Battery Packs
Important • Cameo batteries must be cycled several times before
maximum capacity is realized.
Note • A battery is ”cycled” by fully charging it, then fully discharging
it through normal use.
Chargers
Listed below are the specifications for the Cameo series
chargers:
Model UCN72-4:
Model UCN72-4 is designed to charge up to four batteries
simultaneously. Battery packs may be charged separate-
ly or while plugged into the printer. Typical charge time
is 90 minutes. Input voltage is switch selectable between
110 and 220 V.A.C. The charger is supplied with line
cords compatible with most international standards.
Caution • Do not attempt to charge batteries with the UC72-4 Charger
while printing. Attempting to print while charging batteries can result
in unreliable charging.
UCN72-4 part numbers vary depending on specific coun-
try of use. Consult the factory for appropriate part num-
bers.
Model UCN72:
Model UCN-72 is a wall mounted single charger with a
universal 110 to 230, 50-60 Hz. VAC input. Multiple plug
configurations comply with most international standards.
Caution • Do not attempt to charge batteries with the UCN72 Charger
while printing. Attempting to print while charging batteries can result
in unreliable charging.
UCN72 part numbers vary depending on specific country
of use. Consult the factory for appropriate part numbers.