User Manual

___________________________________________________________________________

WhereLAN III User’s Guide

___________________________________________________________________________ 86

User’s Guide, WhereLAN III draft D1675 rev F

Zebra Confidential

REGULATORY INFORMATION

FCC Regulatory Compliance Information

This device complies with FCC Part 15.247.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference

(2) This device must accept any interference which may cause undesired operation

This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own expense.

RF Notice

Any changes or modifications to equipment not expressly approved by Zebra

Technologies Corporation could void the user’s authority to operate the equipment.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with

minimum distance 20cm between the radiator and your body. This transmitter must not

be co-located or operating in conjunction with any other antenna or transmitter.

Industry Canada Compliance Statements

Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils

radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :

(1) l'appareil nedoit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit

accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en

compromettre le fonctionnement.