User Manual
___________________________________________________________________________
WhereLAN III User’s Guide
___________________________________________________________________________ 76
User’s Guide, WhereLAN III draft D1675 rev F
© Copyright Zebra Technologies, 2012
Zebra Confidential
b. Option 2 is for either the AK-151-00 Cisco 5.2dBi Omni or the
AK-153-00 Cisco 13.5 dBi Yagi antenna. These are both
remotely mounted antenna. Slide the antenna connector
through the Wi-Fi Bracket Clamp and tighten onto the RP-
TNC connector. Recommend 12 to 15 in-lbs of torque (1.4 to
1.7 Nm).
Figure 30 Wi-Fi Bracket Remote Antenna
Then slip the knurled part of the antenna connector back into the Wi-Fi
Bracket clamp, and tighten the retaining screw to 2 in-lbs (0.23Nm).
Mount the antenna according to the recommend instructions provided
with the antenna and in the site design document.
Figure 31 Remote Antenna Clamp
Note: For all outdoor installations use the connector grease supplied with
the unit for this connection.
Knurled Sectio
n
Retainin
g
Screw