User Manual

___________________________________________________________________________

WhereLAN III User’s Guide

___________________________________________________________________________ 53

User’s Guide, WhereLAN III draft D1675 rev F

Zebra Confidential

6.3 3/8ths Threaded Rod

The Location Sensor can be hung via a 3/8 inch (10 mm) threaded rod per the

following instructions. This type of mounting is intended for indoor

installations only, if mounting outdoors use the Pole Mount Kit described in

Sections 6.4. The required supports, threaded rod, nuts, etc., are not included.

• Cut the threaded rod to the desired length and install it directly above

the desired Location Sensor position.

• Thread one nut up 2 in (50 mm) from the bottom of the threaded rod,

with Lock Washer and Washer.

• Place the second nut onto threaded rod, flush with the end of the

threaded rod and install the Location Sensor.

• Tighten the upper nut down on top of the Location Sensor housing.

Figure 6 Threaded-Rod