User Manual

___________________________________________________________________________
WhereLAN III User’s Guide
___________________________________________________________________________
100
User’s Guide, WhereLAN III draft D1675 rev F
© Copyright Zebra Technologies, 2012
Zebra Confidential
Continued 4 LED’s : The Kernel is initialized and is loading the
applications, JFFS2 and CRAM File system.
1 LED (Power): The Application is loading the FPGA’s and DSP’s
NET: Registered protocol family 10
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
ath_rate_amrr: 0.1 (0.9.4)
ath_pci: 0.9.4.5 (0.9.4)
ath_pci: No devices found, driver not installed.
ath_hal: 0.9.18.0 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413,RF5413, REGOPS_FUNC)
wlan: 0.9.4wlan: mac acl policy registered
RAMDISK: Compressed image found at block 0
VFS: Mounted root (ext2 filesystem).
init started: BusyBox v1.2.1 (2011.11.15-16:42+0000) multi-call binary
Disabled Privacy Extensions on device c028dbf0(lo)
BusyBox v1.2.1 (2011.11.15-16:42+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.
WhereLan-III: Mar 19 2012 19:05:04
embedded tag rx service
started rx diagnostic receive process started
Executing coldboot.wsf
Configuring FPGA...
Opening file...done
Checking file...(1243888) bytes
Config mode...done
Loading...done