User's Manual

___________________________________________________________________________

WhereLAN III User’s Guide

___________________________________________________________________________ 18

User’s Guide, WHERELAN III D1675 rev A

Zebra Confidential

6.1 3/8ths Threaded Rod

The Location Sensor can be hung via a 3/8 inch (10 mm) threaded rod per the

following instructions. The required supports, threaded rod, nuts, etc., are not

included.

• Cut the threaded rod to the desired length and install it directly above

the desired Location Sensor position.

• Thread one nut up 2 in (50 mm) from the bottom of the threaded rod,

with Lock Washer and Washer.

• Place the second nut onto threaded rod, flush with the end of the

threaded rod and install the Location Sensor.

• Tighten the upper nut down on top of the Location Sensor housing.

Figure 2 Threaded-Rod