User's Manual

___________________________________________________________________________

WhereLAN III User’s Guide

___________________________________________________________________________ 12

User’s Guide, WHERELAN III D1675 rev A

Zebra Confidential

Hyperterminal via Serial Port

Communication Parameters:

• Null-modem cable, 9-pin female to 9-pin female

• 19200 baud

• 8 data bits, 1 stop bit, no parity, no hardware flow control

Hyperterminal is used in only two instances. The first is for initial

configuration in which the Location Sensor has been configured for DHCP

but there is no DHCP server available. The second instance is if a fault occurs

during the first stage of the boot process, or if visibility to the boot process is

needed for debugging installation problems.

5.3 Location Sensor MAC/ IP Address Configuration

Location Sensors communicate over an Ethernet interface using TCP/IP. For

the LOS-5000-00AB, both the Location Sensor and the embedded Client Card

must be independently configured with their own unique IP addresses. The IP

address of each LS must be recorded and entered into the ZES site file, which

contains the configuration information for each LS, including its location, and

MAC address.

Failure to configure the Location Sensor prior to operation may result in

an inoperative unit.

Each Location Sensor is shipped with a label set containing one label (Figure

1) with the bar coded MAC address of the Location Sensor and Wifi Client

____________

Note

____________