User's Manual

___________________________________________________________________________

WhereLAN III User’s Guide

___________________________________________________________________________ 11

User’s Guide, WHERELAN III D1675 rev A

Zebra Confidential

Do not attempt to communicate with the Location Sensor until it has

completed the first stage of the boot process (i.e., left LED is solid). Doing

so will stop the boot process. The unit must be reset to clear this

condition.

These units are configured using:

• Telnet/SSH via Ethernet (preferred)

• iSensor (Sensor Analyzer)

• WhereWand

• Hyperterminal (or any terminal emulation software) via serial port

Telnet/SSH is the preferred method of communicating with the Location

Sensor, once installed. Use the HyperTerminal is for initial set-up before

being installed on a network for setting static Ip addresses, if DHCP is not

used.

Telnet via Ethernet

Communication Parameters:

• 10/100 Mb/s

• Cat 5 cable/ RJ-45 plug To connect via telnet, open a DOS command

prompt window and type telnet <IP address>,where the IP address is

iSensor (Sensor Analyzer)

____________

Note

____________

Note

____________