User's Manual

http://www.motorola.com/li4278
QUICK START GUIDE
LI4278 LINEAR IMAGER
LI4278 PosterLI4278 Poster
BLACK
PANTONE 285
Perforation
1
2
3
4
OR
OR
OR
OR
Refer to the LI4278 Product Reference Guide, or the cradle
Quick Reference Guides for detailed information about cradle setup.
When charging, use the cradle power supply for faster charge time.
Important: Charge the linear imager scanner for 24 hours before the first full day of use.
Scan a bar code below to choose how the scanner connects to a remote device. Scan CRADLE HOST if connecting to the CR0078 cradle.
Refer to the Product Reference Guide for detailed information.
CRADLE HOST
SERIAL PORT PROFILE (MASTER)SERIAL PORT PROFILE (SLAVE)
HID PROFILE (SLAVE)
Radio Communications Host Types
UNPAIR/DISCONNECT
Unpairing/Disconnection
SET DEFAULTS
BATTERY OFF
STEP 4 - SCAN RADIO COMMUNICATIONS HOST TYPES
HELPFUL BAR CODES
RETURN TO FACTORY DEFAULTS
BATTERY OFF FOR LONG TERM STORAGE/SHIPPING
ADD AN ENTER KEY
To add an Enter key after scanned data, scan all THREE
<DATA><SUFFIX 1>
SCAN OPTIONS
ENTER
1
2
3
ADD A TAB KEY
SCAN SUFFIX
7
0
0
9
1
2
3
4
5
To add a Tab key after scanned data, scan all THREE
123Scan2 is an easy-to-use , PC-based
software tool that enables rapid and
easy customized setup via a bar code or
USB cable. For more information, visit:
http://www.motorola.com/123Scan2.
123SCAN
2
(Carriage Return/Line Feed)
bar codes in numerical order.
Enter key bar codes above in numerical order then
scan all FIVE bar codes below in numerical order.
POST IN WORK AREAPOST IN WORK AREA
STEP 2 - CONNECT HOST INTERFACE
STEP 1 - CRADLE CABLE CONNECTION
See Product Reference Guide
for detailed information
NOTE: Cables may vary depending on configuration
STEP 3 - SET UP INTERFACE (Scan Host Bar Codes)
Cradles
1 Scan Window
2 Scan Trigger
3 LED
4 Beeper
RS-232
USB
Keyboard Wedge
IBM 46XX
RS-232
Scan ONE of the bar codes below
USB
Scan ONE of the bar codes below
Keyboard Wedge
Scan bar code below
IBM 46XX
Scan ONE of the bar codes below
HID KEYBOARD EMULATION
IBM HAND-HELD USB
SNAPI WITHOUT IMAGING
(For use with hands-free base only)
ICL RS-232
NIXDORF RS-232 MODE A
NIXDORF RS-232 MODE B
FUJITSU RS-232
OPOS/JPOS
STANDARD RS-232
PORT 5B
PORT 9B
IBM PC/AT and IBM PC COMPATIBLE
PORT 17
Connect to
Appropriate Host
Power
Host
Host
(if required)
Power
Alternate
Host Groove
Alternate
Power Groove
Host Port
Host Port
Power
Power Port
Power Port
Connect to
appropriate host
Power supply
optional
Power
PRELIMINARY DRAFT