User's Manual
Table Of Contents
- Regulatory Information
- Wireless Device Country Approvals
- Health and Safety Recommendations
- Laser Devices
- Batteries
- Radio Frequency Interference Requirements - FCC
- Waste Electrical and Electronic Equipment (WEEE)
- China RoHS
- Introduction
- Features
- Cradle
- Inserting the Battery
- Inserting the Scanner in the Cradle
- Sending Data to the Host Computer
- Configuring the Scanner
- Radio Communications
- Connect Host Interface
- Set Defaults Bar Code
- Enter Key Bar Code (Carriage Return/Line Feed)
- Tab Key Bar Code
- USB Caps Lock Override
- Scanning
- LED Indications
- Beeper Indications
6 LI3678 Quick Start Guide
Supplying Power to the Cradle
The cradle receives power from one of two sources:
•
An external power supply.
•
When connected to the host through an interface cable that supplies power.
The cradle detects whether the host or the external supply is supplying power. It always draws power from the external
supply when available, regardless of the presence of power from a host.
Mounting the Cradle
For information on mounting the cradle, refer to the documentation included with the cradle.
NOTE Supplying power from a USB host may take longer to charge the linear imager scanner.
Draft 1_Not for Distribution