LI3678 Linear Imager Scanner Quick Start Guide Draft 1_Not for Distribution
LI3678 Quick Start Guide Zebra reserves the right to make changes to any product to improve reliability, function, or design. Zebra does not assume any product liability arising out of, or in connection with, the application or use of any product, circuit, or application described herein.
LI3678 Quick Start Guide 3 Introduction The LI3678 linear imager combines excellent scanning performance and advanced ergonomics to provide the best value in a lightweight laser scanner, ensuring comfort and ease of use for extended periods of time. Features Battery LED Radio LED Scan Window LEDs Trigger Battery Latch Beeper Cradle The cradles serve as a charger, radio communication interface, and host communication interface for the LI3678 cordless linear imager scanner.
LI3678 Quick Start Guide Cradle Parts Canopy Latch PAIR Pairing Bar Code Drain Hole Mounting Screw Hole Mounting Screw Hole Charging/ Communications Contacts LED Foot Latch Page Button Drain Hole Mounting Screw Hole Figure 1-1 Cradle Front View Rubber Feet Mounting Screw Hole Host Cable Latch Host Cable (Under Latch) Host Cable Guide Foot Latch Release Mounting Screw Hole Rubber Feet Figure 1-2 Cradle Back ViewConnecting the Cradle Draft 1_Not for Distribution
LI3678 Quick Start Guide 5 Connecting STB3678/FLB3678 Cradles NOTE Connect the interface cable and power supply (if necessary) in the following order to ensure proper operation of the linear imager scanner and cradle. 1. Connect the appropriate cable to the power supply and an AC power source, if necessary. 2. Insert the interface cable into the host port. 3. Lift the latch and connect the interface cable into the cradle's host port and then close the latch. See Figure 1-3. 4.
LI3678 Quick Start Guide Supplying Power to the Cradle The cradle receives power from one of two sources: • An external power supply. • When connected to the host through an interface cable that supplies power. The cradle detects whether the host or the external supply is supplying power. It always draws power from the external supply when available, regardless of the presence of power from a host. NOTE Supplying power from a USB host may take longer to charge the linear imager scanner.
LI3678 Quick Start Guide 7 Inserting the Battery Batteries are shipped in an Off mode and does not power the scanner. After inserting a new battery into the LI3678 linear imager scanner, you must insert the scanner into a cradle for the battery to turn On. Alternatively, the battery can be placed in the four slot spare battery charger to charge and then inserted in the scanner for immediate use. NOTE The battery resides in a chamber in the linear imager scanner handle. To insert the battery: 1.
LI3678 Quick Start Guide Inserting the Scanner in the Cradle To insert the linear imager scanner in the cradle: 1. Insert the linear imager scanner into the cradle top first. 2. Push the handle until it clicks into place, engaging the contacts in the cradle and linear imager scanner.
LI3678 Quick Start Guide 9 Sending Data to the Host Computer The cradle receives data from the linear imager scanner via a wireless radio connection and transmits it to the host computer via the host cable. The linear imager scanner and cradle must be paired for successful wireless communication. Pairing Pairing registers a scanner to the cradle such that the scanner and cradle can exchange information. The STB3678 and FLB3678 operate in two modes: Point-to-Point and Multipoint-to-Point.
LI3678 Quick Start Guide Connect Host Interface USB The digital scanner automatically detects the host interface type and uses the default setting. If the default (*) does not meet your requirements, scan another host bar code below.
LI3678 Quick Start Guide 11 USB (continued) IBM TABLE TOP USB IBM HAND-HELD USB SNAPI WITHOUT IMAGING SNAPI WITH IMAGING USB OPOS HAND-HELD SSI OVER USB CDC SIMPLE COM PORT EMULATION Draft 1_Not for Distribution
LI3678 Quick Start Guide RS-232 *STANDARD RS-232 ICL RS-232 NIXDORF RS-232 MODE A NIXDORF RS-232 MODE B Draft 1_Not for Distribution
LI3678 Quick Start Guide 13 RS-232 (continued) FUJITSU RS-232 OPOS/JPOS Keyboard Wedge *IBM AT NOTEBOOK IBM PC/AT and IBM PC COMPATIBLE Draft 1_Not for Distribution
LI3678 Quick Start Guide IBM 46XX NON-IBM SCANNER EMULATION (PORT 5B) HAND-HELD SCANNER EMULATION (PORT 9B) TABLE-TOP SCANNER EMULATION (PORT 17) Draft 1_Not for Distribution
LI3678 Quick Start Guide 15 Set Defaults Bar Code RETURN TO FACTORY DEFAULTS Enter Key Bar Code (Carriage Return/Line Feed) Add an Enter key after scanned data. ADD AN ENTER KEY (CARRIAGE RETURN/LINE FEED) Tab Key Bar Code Add a Tab key after scanned data.
LI3678 Quick Start Guide Scanning Aiming Draft 1_Not for Distribution
LI3678 Quick Start Guide 17 LED Indications Indication LED Hand-Held Scanning The scanner is on and ready to scan, or no power to the scanner Off A bar code is successfully decoded Green Transmission error Red Hand-Free (Presentation) Scanning No power to the scanner Off The scanner is on and ready to scan Green A bar code is successfully decoded Off momentarily Transmission error Red Beeper Indications Indication Beeper Sequence Power up Low/medium/high beep A bar code is successfully
LI3678 Quick Start Guide Regulatory Information For devices with Symbol, or Symbol Technologies Inc., etc. on the Manufacturing Label and for devices manufactured at Reynosa, or any other Zebra factory facilities: This device is approved under Zebra Technologies Corporation. This guide applies to Model Number: LI3678. All Zebra devices are designed to be compliant with rules and regulations in locations they are sold and will be labeled as required.
LI3678 Quick Start Guide 19 Warnings for Use of Wireless Devices CAUTION Please observe all warning notices with regard to the usage of wireless devices. Safety in Hospitals Wireless devices transmit radio frequency energy and may affect medical electrical equipment. Wireless devices should be switched off wherever you are requested to do so in hospitals, clinics or healthcare facilities. These requests are designed to prevent possible interference with sensitive medical equipment.
LI3678 Quick Start Guide Laser Devices Class 2 laser scanners use a low power, visible light diode. As with any very bright light source such as the sun, the user should avoid staring directly into the light beam. Momentary exposure to a Class 2 laser is not known to be harmful. The following statement is required to comply with US and international regulations.
LI3678 Quick Start Guide 21 Battery Safety Guidelines The area in which the units are charged should be clear of debris and combustible materials or chemicals. Particular care should be taken where the device is charged in a non-commercial environment. • Follow battery usage, storage, and charging guidelines found in the user's guide. • Improper battery use may result in a fire, explosion, or other hazard.
LI3678 Quick Start Guide The use of 5 GHz WLAN's, for use in the US, have the following restrictions Radio Frequency Interference Requirements- Canada CAN ICES-3 (B)/NMB-3(B) Radio Transmitters This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Chile Este equipo cumple con la Resolución No 403 de 2008, de la Subsecretaria de telecomunicaciones, relativa a radiaciones electromagnéticas. China http://www.zebra.com/contact Taiwan South Korea For a radio equipment using 2400~2483.5MHz or 5725~5825MHz, the following two expression should be displayed: Ukraine Thailand เครื่ องโทรคมนาคมและอุปกรณ์น้ ี มีความสอดคล้องตามข้อกําหนดของ กทช.
LI3678 Quick Start Guide Waste Electrical and Electronic Equipment (WEEE) Bulgarish: За клиенти от ЕС: След края на полезния им живот всички продукти трябва да се връщ ат на Zebra за рециклиране. За информация относно връщането на продукти, моля отидете на адрес http://www.zebra.com/weee. Čeština: Pro zákazníky z EU: Všechny produkty je nutné po skončení jejich životnosti vrátit společnosti Zebra k recyklaci. Informace o způsobu vrácení produktu najdete na webové stránce: http://www.zebra.
LI3678 Quick Start Guide 25 China RoHS Draft 1_Not for Distribution
LI3678 Quick Start Guide Zebra Technologies Corporation Lincolnshire, IL U.S.A. http://www.zebra.com Zebra and the stylized Zebra head are trademarks of ZIH Corp., registered in many jurisdictions worldwide. All other trademarks are the property of their respective owners. ©2015 ZIH Corp and/or its affiliates. All rights reserved.
