User Manual
___________________________________________________________________________
Infrastructure Installation Guide
___________________________________________________________________________ 24
Location Sensor Installation Guide D0405 rev PA6
Copyright WhereNet, Corp. 2001
WhereNet Confidential
This allows a 9 foot (3 m) “service loop” margin if the Location Sensor position
must be readjusted after the AC power is installed.
For outdoor installations the power supply must be installed within a suitable
waterproof housing. Follow local and national building codes.
9.2 Timing
For most indoor and some outdoor applications the Location Sensor requires at
least one timing cable to be connected to other nearby Location Sensor units. The
site design document will specify which Location Sensors will be connected
together. Each of the three timing ports on the Location Sensor is an identical bi-
directional link. The cable and connector types are specified in section 4 above.
For a reliable system operation, the jacket of the timing cable must be
securely crimped inside the RJH connector. Standard eight conductor cat 5
cable is too large for crimping in the 4 wire connector; the recommended 4
wire cable must be utilized to ensure a proper crimp.
_____________
_____________
____________
______________