User Manual

___________________________________________________________________________
Infrastructure Installation Guide
___________________________________________________________________________ 22
Location Sensor Installation Guide D0405 rev PA6
Copyright WhereNet, Corp. 2001
WhereNet Confidential
8.2 3/8ths Threaded Rod
The Location Sensor can be hung via a 3/8 inch (10 mm) threaded rod per the
following instructions. The required supports, threaded rod, nuts, etc., are not
included.
Cut the threaded rod to the desired length and install it directly above the
desired Location Sensor position.
Thread one nut up 2 inches (50 mm) from the bottom of the threaded rod.
Place the Location Sensor onto the threaded rod and install the second nut.
Tighten the upper nut down on top of the Location Sensor housing.
8.3 Pole Mount
The required pole mount kit, catalog number RM-410-00, must be ordered
separately. The Location Sensor can be mounted to a pole per the following
instructions:
TBD