User's Manual

Setup and Deployment Guide
If Geo-location is to be demonstrated, then in the Geo Location box, select “Enable
Position Calculations”, and select the default interval of 10 seconds. Select
“Enable Position Reporting”, select the default interval of 10 seconds. Enter the
map server’s IP address.
c.
d.
Note: If Geo-location will not be demonstrated, ensure that both “Enable Position
Calculations” and “Enable Position Reporting” are not checked.
Enter the IP address to send traps to in the SNMP box.
8. Close the Device Manager utility.
Once the system components have been installed, there are two basic tests to verify correct
operation the system. The first test is to perform ping tests to each device and the second test
is to verify access the Internet.
5.6 Testing
5.6.1 Basic MiSC Tests
To verify the basic connectivity of the MiSC, conduct the following from the MeshManager
server:
• Ping an IAP
• Ping the NAT Router
• Ping the Edge Router
5.6.2 Wireless System Tests
From Device Manager, complete the following to verify correct operation of the system:
1. Ping the transceiver of the deployed IAPs (10.0.x.2)
• From the Device Manager drop down menu, select Preferences/Use Transceiver
Address
• For each IAP in the device tree, right click and select Ping Device
2. Ping the transceiver of the deployed WRs (10.0.x.2)
• From the Device Manager drop down menu, select Preferences/Use SBC Address
• For each WR in the device tree, right click and select Ping Device
3. Ping the transceiver of each Subscriber Devices (10.0.x.2)
• From the Device Manager drop down menu, select Preferences/Use Transceiver
Address
• For each SD in the device tree, right click and select Ping Device
5.6.3 Internet Test
If the system has been configured to access the Internet, complete the following to verify
correct network setup:
1. From a SD, start the web browser and enter a URL such as
http://www.MeshNetworks.com
.
21