User's Manual

Setup and Deployment Guide
IAP1
IAP2
core
router
edge
router
internet
MeshManager server
switch
server subnet
wireless subnet
Geo server
CISCOSYSTEMS
CISCOSYSTEMS
Figure 8. Basic MiSC Configuration
The following describes the parameters for setting up the network:
• All
wireless devices must be within the same subnet.
•
currently uses the non-routable 10.x.x.x (8 bit) subnet as defined in RFC 1918.
• The IAP will use DHCP to obtain an address, and it must be returned a 10.x.x.x address.
• All MeshNetworks devices (other than the IAP) currently have fixed addresses of
10.0.x.x with a default gateway of 10.0.0.1.
• All Mesh devices (other than the IAP) currently expect a DNS server at the IP address
192.168.50.20. If a DNS server is not available at this address, subscriber device hosts
will be unable to resolve web URLs. (This can be overcome by manually setting a DNS
server address in the TCP/IP configuration for the subscriber device host. See Notes in
Appendix B.)
• A VPN needs to be set up between the Network Operator and MeshNetworks’ Support
group.
16