User's Manual

Setup and Deployment Guide
4.2 WR Assembly
Figure 7 shows the connection points on a WR box.
Antenna
Serial Port
Power In (4 pin)
Figure 7. WR Connection Points
Assemble the WR using the following procedure:
1. Insert the Antenna into the N-type Connector on the top of the box, and rotate to close.
2. Insert the Power Plug into the 4-pin Connector.
3. The Serial Port should remain unconnected; it is used for maintenance/debug purposes.
4. The transceiver number is recorded on the back of the WR. Record this number, as it
will be required to configure and test the device.
4.3 Deployment
The WR may be mounted on either a flat surface or a pole, depending on which optional bracket
is selected.
When deploying the WR, the antenna should be a minimum of 30 inches from any nearby metal
poles to avoid interference in the RF pattern. The antenna must also be fixed-mounted on
outdoor permanent structures with a separation distance of at least 2 meters from all persons
and must not be co-located or operating in conjunction with any other antenna or transmitter.
Users and installers must be provided with antenna installation and transmitter operating
conditions for satisfying RF exposure compliance.
The installation sight must have AC power available for the WR.
It is the responsibility of the Network Operator to ensure that the installation complies with any
local building codes.
4.4 Initial Configuration
The configuration process for Geo-Location is the same as for the IAP. Refer to Section 3.4.
13