User's Manual

Setup and Deployment Guide
3.5 Testing
Once deployed, verify the health of the IAP with the following procedure:
1. The transceiver number and the SBC number are recorded on the back of the IAP.
Record these numbers, as they will be required in Step 3.
2. Apply power to the IAP.
3. Obtain the transceiver number from the IAP box. Substitute the number for the “x” in the
following commands:
4. From a Subscriber Device, issue the ping command for the transceiver: ping 10.0.x.2.
5. Next ping the SBC: ping 10.0.x.1
This verifies that both the transceiver and SBC are alive.
11