User's Manual
Table Of Contents
- _
- Chapter 1: Product Introduction
- HotZone Duo Infrastructure Devices
- IAPs and MWRs within a HOTZONE DUO Wireless Network
- HotZone Duo Infrastructure Device Specifications
- Chapter 2: Infrastructure Device Installation
- Software Requirements
- MWR and IAP Hardware Installation Notes
- _
- Equipment Specification
- Ports and Connections
- Operator Supply List
- Optional Antennas
- HotZone Duo Infrastructure Device Label
- Infrastructure Device MAC Address Table
- Infrastructure Device Assembly
- Infrastructure Device Deployment and Installation
- Grounding Considerations
- Assembling the IAP and the MWR Device
- Initial Infrastructure Device Configuration Information
- Device Connectivity Testing
- Chapter 3: Device Configuration
- Adding an Infrastructure Device in MeshManager
- Chapter 4: License Information
- Motorola End User License Agreement
- _
- Third Party Licensing Agreements
- OpenSSL - Copyright and License Information
- XSupplicant version 1.2.3 - Copyright and License Information
- Hostapd - Copyright and License Information
- Chapter 5: Customer Information
- Customer Service Information
- Obtaining Support
- System Information
- Return Material Request
- Radio Products and Services Division
- Radio Products and Services Division Telephone Numbers
- Returning System Components to Motorola
- Returning FREs
- Chapter 6: Certification and Safety Information
- FCC Regulatory Information
- Federal Communications Commission (FCC) Statement:
- FCC RF Radiation Exposure Statement
- Safety Information for the HOTZONE DUO Products
- Safety Certification
HotZone Duo 1.0 IAP and MWR Users Guide
HotZone Duo Infrastructure Device Specifications
The following specifications apply to the HotZone Duo Infrastructure Devices as described in the table
below:
Table 1-1 HotZone Duo Device Specifications
HotZone Duo Radio Characteristics
Primary Radio Operating Freq. (GHz) 2.4 to 2.4835 (2nd ISM band)
Secondary Radio Operating Freq. (GHz) 5.725 to 5.825 (U-NII band)
Wi-Fi Support 802.11b/g at 2.4GHz; 802.11a at 5.8GHz
RF Modulation CCK / OFDM
Output Power (Maximum) 36 dBm EIRP
Power Control 1dB increments
Receive Sensitivity -77 dBm (at 54 Mbps) to -100 dBm (at 1 Mbps)
Antenna Type Two (2) omnidirectional, 8 dBi (for 2.4 GHz Radio) and 10 dBi (for 5.8
GHz Radio)
Antenna Connector N-Type
Routing
Routing Engine MeshConnex Layer 2 routing with Layer 1 situational-awareness
Routing Protocol Patented, hybrid proactive/reactive routing (low latency & fast route
convergence)
IEEE 802.11s Support Upgradeable to final IEEE 802.11s standard via OTA software updates
Network
Network Management Software MeshManager Element Management System via secure SNMP v.3
Network Interface Ruggedized 10/100Mbps Ethernet (RJ-45) port with surge suppression
Network Segmentation
Multiple SSIDs with VLAN mapping
Quality of Service (QoS) 802.11e, weighted fair queuing and IP precedence bits (ToS) supported via
DSC
Security
Virtual LAN (VLAN) Supports up to sixteen (16) per node, or 4094 per network
Client Encryption Support WEP, WPA (TKIP) and WPA2 (AES, 802.11i)
Internodal Encryption Intra-Mesh Security
Authentication 802.1X (Infrastructure/Client) and MAC address hardware authentication
Power
Power Requirements 120-240 VAC (with +/- 20% variation at 50-60Hz)
Power Connector AC, NEMA 5-15 power cord • 8 ft (2.44m)
Error! Reference source not found. July 2006