User Manual
Operation
WiData Firefly System Hand Held Communicator User’s Guide
5
Operation
Configuration and Setup
The WiData Firefly Hand Held Communicator does not require any special configuration or setup to operate with the
Firefly application software loaded on the handheld computer.
Operation
The WiData Firefly Hand Held Communicator application software should automatically run on power up of the handheld
computer. Most applications allow the user perform one or more of the following functions:
• Read data from tag memory
• Write data to tag memory
• Turn tag DSSS blink on and set the blink rate
• Turn tag DSSS blink off
• List Ids of tags within the OOK/FSK range of the Hand Held Communicator
• Locate a specific tag by report the signal tag’s OOK/FSK signal strength
• Upload data to the Firefly Data Base using DSSS transmit mode.
All application software is pre-configured to individual system requirements before system installation. All available
functions are menu selectable through easy on screen instructions.