User's Manual
Table Of Contents
- Patents
- Warranty
- Revision History
- Table of Contents
- About This Guide
- Quick Start
- Getting Started
- Installation and Communication
- Administrator Console
- Setup Examples
- Troubleshooting
- Technical Specifications
- Firmware Upgrade Procedures
- Java Upgrade Procedures
- Static IP Configuration
4 - 30 FX Series RFID Readers Integrator Guide
File Upload
•
Click Choose to browse to and choose a cab file containing the incremental updates for the reader partitions.
•
Click Start Update to load the firmware and write the new files onto the flash. The application shuts down and
the files listed in the Response.txt file are downloaded, validated, and programmed into flash. The reader
reboots. If all the files are not downloaded or are corrupted during the download, they are not programmed
into flash, and the old partitions remain.
Partition download and flash programming takes about 15 minutes. Do not reboot or power off the reader while the
green LED is blinking.
Figure 4-28
File Based Firmware Update Window