User's Manual

4 - 24 FX Series RFID Readers Integrator Guide
System Time Management
Use the Date/Time page to set the date and time value or to specify an NTP synchronization server. To specify an
NTP server, enter the NTP Server IP address in the
NTP Server Address box, and click Set NTP Server Address.
Perform a
Commit to affect the change.
To adjust the time manually, select the value for the local time and click the Set Date and Time. The reader clock
resets to the exact value provided (if the operation is successful or, an appropriate message displays the error). Set
time zones (including use of Daylight Savings) from this page. The date/time and time zone changes take effect
immediately and do not require a
Commit.
To set the date and time:
1. Click Date Time in the Administrator Console window. The System Time Management window appears.
Figure 4-24 System Time Management Window
2. To synchronize the clock with a particular SNTP server, enter the server IP address in the SNTP Server
Address:
field, click Set SNTP Parameters, and perform a Commit (see Commit/Revert on page 4-31).
3. To set the system time manually, use the drop-down lists to select units of time, then click Set Date and Time.
4. Use the Time Zone: drop-down list to set the time zone, then click Set Time Zone.
NOTE SNTP (Simple Network Time Protocol) is an Internet standard protocol (built on TCP/IP) that assures
accurate synchronization to the millisecond of computer clock times in a network of computers.
It is essential to have a DNS server configured to allow adding an SNTP server on this page. If using a
static IP address, enter a valid DNS server address in the TCP/IP configuration. If this address is not
present, the reader can not add an SNTP server address from this page. Ensure the DHCP server sets
up the DNS server address while issuing the IP address.