User's Manual
Table Of Contents
- Warranty
- Service Information
- Software Support
- Introduction
- Features
- Installing a micro SIM Card (ET55 Only)
- Install a micro SD Card
- Charging the ET5X
- Using the Camera
- Reading NFC Cards And RFID Tags
- Regulatory Information
- UL Listed Products with GPS
- Radio Modules
- Wireless Devices Country Approvals
- Health and Safety Recommendations
- Power Supply
- Batteries
- Radio Frequency Interference Requirements-FCC
- Radio Frequency Interference Requirements - Canada
- Marking and European Economic Area (EEA)
- Other Countries
- Waste Electrical and Electronic Equipment (WEEE)
- End User License Agreement
- CMM Disclosure
8 ET5X Enterprise Tablet
1. Open access door.
2. Insert microSD card into slot with contacts facing down.
3. Press the card in to ensure that it is seated properly.
4. Close access door.
Charging the ET5X
Use the Communication and Charging Cradle, Rugged Communication and Charging Cradle or
Charge Only Cradle to charge the ET5X.
Setup the Charge Only Cradle or Communication Cradle, power supply, PWRS-14000-148R and
3-wire country specific AC Line Cord, sold separately.
NOTE
The Charge Only Cradle (CRD-ET5X-1SCG1) and the Communication and Charge
Cradle (CRD-ET5X-1SCOM1) come with two inserts; tall insert and short insert. Install the
tall insert when using an ET5X without a Rugged Frame and Expansion Back. Install the
small insert when using an ET5X with an Expansion Back and without a Rugged Frame. Do
not install either insert when using the ET5X with the Rugged Frame.
The Rugged Communication and Charge Cradle (CRD-ET5X-1SCOM1R) does not come
with inserts. Use with ET5X and Rugged Frame with IO Adapter.
Communication CradleCharge Only Cradle
Short Insert
Rugged Communication Cradle
Tall Insert