User's Manual
Table Of Contents
- Warranty
- Service Information
- Software Support
- Introduction
- Features
- Installing a micro SIM Card (ET55 Only)
- Install a micro SD Card
- Charging the ET5X
- Using the Camera
- Reading NFC Cards And RFID Tags
- Regulatory Information
- UL Listed Products with GPS
- Radio Modules
- Wireless Devices Country Approvals
- Health and Safety Recommendations
- Power Supply
- Batteries
- Radio Frequency Interference Requirements-FCC
- Radio Frequency Interference Requirements - Canada
- Marking and European Economic Area (EEA)
- Other Countries
- Waste Electrical and Electronic Equipment (WEEE)
- End User License Agreement
- CMM Disclosure
18 ET5X Enterprise Tablet
Radio Frequency Interference Requirements-FCC
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help.
Radio Transmitters (Part 15)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Radio Frequency Interference Requirements - Canada
CAN ICES-3 (B)/NMB-3(B)
Radio Transmitters
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radio électrique
subi même si le brouillage est susceptible d'en compromettre le fonctionnement.
For RLAN Devices:
The use of 5 GHz RLAN's, for use in Canada, have the following restrictions:
• Restricted Band 5.60 - 5.65 GHz
Pour les équipements RLAN:
L'utilisation de la bande RLAN 5 GHz au Canada présente les limitations suivantes :
• Bande restreinte 5.60 - 5.65 GHz
Label Marking: The Term 'IC:' before the radio certification only signifies that Industry Canada technical
specifications were met.
Etiquette de marquage: Le terme "IC" avant la certification radio signifie que le produit est compatible
avec le spécification Industrie Canada.
The use of RLAN's, for use throughout the EEA, have the following restrictions:
Marking and European Economic Area (EEA)