User's Manual
Table Of Contents
- Warranty
- Service Information
- Software Support
- Introduction
- Features
- Installing a micro SIM Card (ET55 Only)
- Install a micro SD Card
- Charging the ET5X
- Using the Camera
- Reading NFC Cards And RFID Tags
- Regulatory Information
- UL Listed Products with GPS
- Radio Modules
- Wireless Devices Country Approvals
- Health and Safety Recommendations
- Power Supply
- Batteries
- Radio Frequency Interference Requirements-FCC
- Radio Frequency Interference Requirements - Canada
- Marking and European Economic Area (EEA)
- Other Countries
- Waste Electrical and Electronic Equipment (WEEE)
- End User License Agreement
- CMM Disclosure
Quick Reference Guide 17
• If you suspect damage to your equipment or battery, contact Zebra support to arrange for
inspection.
Removing the Battery
1. Lift the notched corner of the battery cover.
2. Carefully lift the battery cover off the ET5X.
3. On the 8” version, push the two locking tabs up, then pull up on the tab to remove battery.
On the 10” version, push the two locking tabs up (1), then, using index fingers, lift the battery up (2).
Pull Tab
8” Version
Locking Tabs
2.LIFT
UP
2.LI
FT
U
P
1.RELEAS
E LO
C
KING
1
.
R
E
LEA
S
E
L
OC
K
I
NG
10” Version