User's Manual
Table Of Contents
- Warranty
- Service Information
- Software Support
- Introduction
- Features
- Installing a micro SIM Card (ET55 Only)
- Install a micro SD Card
- Charging the ET5X
- Using the Camera
- Reading NFC Cards And RFID Tags
- Regulatory Information
- UL Listed Products with GPS
- Radio Modules
- Wireless Devices Country Approvals
- Health and Safety Recommendations
- Power Supply
- Batteries
- Radio Frequency Interference Requirements-FCC
- Radio Frequency Interference Requirements - Canada
- Marking and European Economic Area (EEA)
- Other Countries
- Waste Electrical and Electronic Equipment (WEEE)
- End User License Agreement
- CMM Disclosure
Quick Reference Guide 11
1. Open the Camera application. The Camera Indicator LED lights red.
2. Point the ET5X camera at an object.
3. Touch the on-screen shutter button to take a photo or record a video.
Reading NFC Cards And RFID Tags
The ET5X supports reading NFC cards and RFID tags. The NFC antenna is located on the back of the
device under the NFC logo.
With an NFC enabled application open, bring the NFC card toward the antenna. Depending upon the
application, an audio or visual indication indicates successful reading of the card.
Regulatory Information
This device is approved under Zebra Technologies Corporation.
This guide applies to the following Model Numbers: ET50NE, ET50NT, ET50PE, ET50PT, ET55AE,
ET55AT, ET55BE, ET55BT, ET55RE, ET55RT, ET55TE and ET55TT.
All Zebra devices are designed to be compliant with rules and regulations in locations they are sold
and will be labeled as required.
NFC Antenna
Location