User's Manual

Standard Default Parameters A - 5
Port Address None Selected 9-4
Convert Unknown to Code 39 Disable 9-5
Ignore Beep Disable 9-5
Ignore Bar Code Configuration Disable 9-6
Wand Emulation Host Parameters
Wand Emulation Host Types Symbol OmniLink Interface
Controller
1
10-4
Leading Margin 80 msec 10-5
Polarity Bar High/Margin Low 10-6
Ignore Unknown Characters Send 10-6
Convert All Bar Codes to Code 39 Disable 10-7
Convert Code 39 to Full ASCII Disable 10-8
Scanner Emulation
Beep Style Beep on Successful Transmit 11-4
Parameter Pass-Through Parameter Process and Pass
Through
11-5
Convert Newer Code Types Convert Newer Code Types 11-6
Module Width 20 µs 11-6
Convert All Bar Codes to Code 39 Do Not Convert Bar Codes to
Code 39
11-7
Code 39 Full ASCII Conversion Disable 11-7
Transmission Timeout 3 sec 11-8
Ignore Unknown Characters Ignore Unknown Characters 11-9
Leading Margin 2 ms 11-9
Check for Decode LED Check for Decode LED 11-10
123Scan
2
Configuration Tool
123Scan
2
Configuration None
1
12-1
OCR Programming Parameters
OCR-A Disable 13-3
Table A-1 Standard Default Parameters Table (Continued)
Parameter Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.