User's Manual

Scanner Emulation Interface 11 - 3
Scanner Emulation Parameter Defaults
Table 11-1 lists the defaults for the Scanner Emulation host. To change any option, scan the appropriate bar
code(s) provided in the Scanner Emulation Host Parameters section beginning on page 11-4.
Scanner Emulation Host
Scan the bar code below to enable the Scanner Emulation host.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 11-1 Scanner Emulation Default Table
Parameter Default Page Number
Beep Style Beep on Successful Transmit 11-4
Parameter Pass-Through Parameter Process and Pass Through 11-5
Convert Newer Code Types Convert Newer Code Types 11-6
Module Width 20 µs 11-6
Convert All Bar Codes to Code 39 Do Not Convert Bar Codes to Code 39 11-7
Code 39 Full ASCII Conversion Disable 11-7
Transmission Timeout 3 sec 11-8
Ignore Unknown Characters Ignore Unknown Characters 11-9
Leading Margin 2 ms 11-9
Check for Decode LED Check for Decode LED 11-10
1
User selection is required to configure this interface and this is the most common selection.
Undecoded Scanner Emulation Host